Updating xbox 360 with thumb drive


Note: The version of the console software available here is from 12 December, 2013.Copy to a USB flash drive If you cannot connect your Xbox 360 console to the Internet, you can copy the console update from your computer to a USB flash drive and then install it on the console.Plug the cable into the new drive and install it into the bay.First line up the screw holes in the drive with those in the bay and then screw into place.Invert the Xbox on a flat surface and remove the five torx screws from the bottom using the screwdriver. Next we must prepare the new hard drive for cloning.Following the instructions that came with your hard drive, set the unit to slave / secondary mode using the included plastic jumper.



Now plug in your XBox, cross your fingers and power it on!Next the hard drive bay taken out to allow the removal of the original hard drive.Remove the PATA ribbon cable (gray) from the IDE connector at the back of the drive.For my unit this meant placing the jumper on the set of pins second from the right (see photo).



Updating xbox 360 with thumb drive comments


  • Unable to update Xbox 360 dashboard AfterDawn Discussion Forums profil de paulette60

    paulette60

    Unable to update Xbox 360. put in the thumb drive before turning the xbox on. As they were updating from a backup, the 360 can no longer read it as it's now.…